Kampinis šlifuoklis | greičio reguliavimas | 1400W | 125 mm (YT-82099)

Aprašymas:
Gamintojas:
Mark

Yato

Symbol

YT-82099

Series

GRE

Application

cutting stainless steel, grinding welds, grinding concrete with a cup wheel

Kit contents

angle grinder, additional handle, abrasive wheel guard, key for fastening the abrasive wheel

Turnover

3000-12000 min⁻¹

Mass

2 kg

Tension

230-240Vac

Power

1400W

Cable length

3 m

Level of security

IPX0

Frequency

50 Hz

Electrical insulation class

II

sound pressure

89.3 ± 3.0dB(A)

Acoustic power

100.3 ± 3.0dB(A)

Electronically adjustable speed

Yes

Vibrations

6.95 ± 1.5 m/s²

Grinding wheel diameter

125mm

Abrasive wheel bore diameter

22mm

Spindle thread size

M14

Very powerful and at the same time handy angle grinder with speed control. The copper windings of the rotor and stator are double insulated with a flexible varnish that does not chip off when exposed to high temperatures, protecting the motor from damage.

The machine has a soft start system to protect the toothed gear. It also has a built-in low-speed constant speed function, making stainless steel grinding work with the flap disc efficient and without damaging the machine.

The slim housing provides a comfortable grip even during long-term operation for the safety and comfort of the operator.

Spare brushes are included in the set, and their replacement does not require dismantling the whole machine, but only removing its rear part (part of the housing in black).

The bevel gear is precisely fitted and made of steel with a hardness of 53-56 HRC and has a high torque.

Speed regulation in the range of 3000-12000 rpm is based on an electronic system that allows automatic selection of power from the network in the case of work with strong pressure at low / medium speed: inox steel, grinding welds or grinding concrete with a cup wheel.

The grinder allows you to cut steel elements and reinforced concrete or stoneware much faster than devices with lower power and is less susceptible to wedging the disc in the material.

The device is designed for grinding work thanks to the rear handle and the switch located right next to the handle. This construction makes it easier to exert pressure on the machine and does not cause operator fatigue even when sanding large surfaces.